Hale FoamLogix Water Flow Calibration Manuel d'utilisateur télécharger pdf

Quick Start Guide

(FoamLogix Water Flow Calibration)

1. Start the pumping unit per the

manufacture’s operating instructions.

Set pump pressure and flow to the low

end of the units intended performance

(using a calibrated Pitot, nozzle, etc.).

2. Press and hold the DISPLAY button

(

i) on the FoamLogix display until

PASS is shown, approximately 2

seconds

(See Figure 1.)

3. With the DISPLAY button (

i) pressed,

press the INCREASE button 4 times.

( ).

A u is shown with each INCREASE

button ( ) press.

(See Figure 2 in the

next column.)

4. Release the DISPLAY (

i) button. The

display shows CAL for 2 seconds in-

dicating the calibration mode has been

entered. (See Figure 3 in the next

column.)

5. The display shows the water flow rate.

Refer to the complete product manual

for the rate unit settings; i.e., GPM,

LPM, etc. (See Figure 4.)

Calibration

Figure

THIS QUICK START GUIDE IS ONLY INTENDED AS A BRIEF OVERVIEW TO THE

OPERATION OF THE FOAMLOGIX 2.1A, 3.3 AND 5.0 SYSTEMS AND IS NOT

INTENDED TO BE A REPLACEMENT FOR THE INSTALLATION / OPERATION

MANUAL (HALE P/N: 029-0020-74-0 OR 029-0020-68-0) PROVIDED WITH EACH

SYSTEM. ALSO AVAILABLE ON-LINE – WWW.CLASS1.COM.

1 2

Quick Start Guide 1
Web 2

Résumé du contenu

Page 1 - Quick Start Guide

Quick Start Guide(FoamLogix Water Flow Calibration)1. Start the pumping unit per themanufacture’s operating instructions.Set pump pressure and flow to

Page 2 - Web

Class 1 ● Unit of IDEX Corporation607 NW 27th Avenue ● Ocala, FL 34475 U.S.A.Phone: 1-800-533-3560 ● 352-629-5020Fax: 1-800-5230-3473 ● 352-629-2902

Commentaires sur ces manuels

Pas de commentaire

Hale FoamLogix Water Flow Calibration Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Hale FoamLogix Water Flow Calibration. Hale FoamLogix Water Flow Calibration User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Hale FoamLogix Water Flow Calibration